Eurocave Wine Bar 2.0 Mode D'emploi page 22

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
PROTECTION position
1
1
The air vacuum system head is in "service" position
2
Turn the plunger to the left
3
Move the plunger to the low position. The air vacuum
system head is now in "protection" position
Protecting your open bottles from oxidation:
1
Open the compartment door.
2
If the air vacuum system head is in the protection
position, place the neck of the open bottle directly
under one of the air vacuum plungers and raise the
bottle whilst centring it vertically in the bottle holder
(ensure that there are no objects that could obstruct
the bottle neck).
Removing a bottle
1
Open the compartment door
2
Remove the bottle without handling the air vacuum
system head.
3
If need be, place the air vacuum system head in "serving"
mode. We do not recommend that you activate vacuum
sealing each time you handle the bottle but rather at
The lighting of your appliance:
Your Wine Bar 2.0 has multicolour LED lighting. It is supplied with a
remote control for setting the lighting functions.
The sensor of the lighting controller is located on the front between
the two doors. When using the remote control, always ensure that
you are standing in front of the appliance.
The remote control can be stored by placing it against the back cover,
thanks to the magnet.
-GB10-
2
3
1
2
3
SERVING position
2
1
1
The air vacuum system head is in "protection"
position. Raise the plunger
2
Turn it to the right to maintain it in its upper position.
3
The air vacuum system head is now in "service"
position
3
If the air vacuum system head is in serving position,
first place it in protection mode. To do so, turn the
plunger to the left to release it and move it down to
the low position.
Then place the neck of the open bottle under the air
vacuum plunger and raise the bottle until it is in the
vertical position
4
The air vacuum system then activates itself for a few
seconds (the appliance is then operating independently),
5
Close the compartment door
the end of service or when you have finished using the
appliance (vacuum sealing a bottle repeatedly can affect
the duration of preservation of wine).
4
Close the door
N.B: The pump will activate itself again (which is normal)
for approximately 10 seconds.
M
1
2
3
4
Light
3

Publicité

Table des Matières
loading

Table des Matières