Protecting The Environment And Energy-Saving; Installation - Eurocave Wine Bar 2.0 Mode D'emploi

4 - PROTECTING THE ENVIRONMENT
•
Disposing of packaging
•
The packaging used by Eurocave Professional is produced in recyclable materials.
•
After unpacking your cabinet, take the packaging to a refuse collection point. For the most part,
it will be recycled.
•
Recycling: a caring gesture
•
Electronic and electrical equipment has potentially harmful effects on the environment and human
health, owing to the presence of dangerous substances.
•
Therefore, you must not trash electrical and electronic equipment with non-sorted municipal
waste.
•
When purchasing a new Eurocave Professional product (wine cabinet, cellar conditioner, Vin au
Verre, Wine Bar 2.0), you can entrust the recycling of your old appliance to your Eurocave Professional dealer.
•
Speak to your Eurocave Professional dealer, he will advise you on the disposal and collection arrangements set up
within the Eurocave Professional network.
•
In compliance with legislation on protecting and caring for the environment, your appliance does not contain C.F.C.s.
•
Energy-saving
•
Install your cabinet in a suitable location and observe the recommended temperature ranges.
•
Keep the door open for as short a time as possible.
•
Ensure that the door seal is in good condition and that it is not damaged. If they are, contact your Eurocave
Professional dealer.
Disable unusable appliances by unplugging them and removing the power lead.
•
Check, when your cabinet is delivered, that it does not have any external faults (impact, warping...).
•
Open the door and check the integrity of your appliance (walls, air vacuum heads, electronics and air vacuum system).
If there is a problem, contact your Eurocave Professional dealer.

Installation

Transport your appliance to the chosen location.
It must:
•
be open on the outside to allow air to circulate
(not a closed cupboard...)
•
not be close to any heat source,
•
not be too damp,
•
have a stable, flat support,
•
have a power supply (standard socket, 16 A, earthed with circuit breaker, 30 mA* (*not applicable to some countries).
Precautions
•
Do not place your cabinet in an area likely to be flooded.
•
Do not position your cabinet near to a source of heat or expose it to the effects of direct sunlight.
•
Prevent water from splashing on the entire rear section of the appliance.
•
Position your appliance so that there is a minimum space of 5-10 cm between the wall and the rear wall of your cabinet.
•
Arrange the power lead so that it is accessible and does not come into contact with any component of the appliance.
•
Ensure that the mains transformer is placed away from any heat source.
•
Do not obstruct the ventilation holes at the back of the appliance.
Any LEDs must only be replaced by a qualified electrician.
Do not plug several appliances into a multi-socket and do not use an extension cord.
AND ENERGY-SAVING
5 - INSTALLATION
-GB7-