Lv- Changing The Layout Of The Cabinet; Ayout Torage; C Ommissioning Your Wine Cabinet; I- Connecting - Eurocave 92 Série Mode D'emploi

6- l
IV - Modifying the layout of your cabinet
To change the position of a storage shelf, you must first of all unload the shelf, then remove
the shelf supports taking care to reinstall them as shown opposite:
To change the position of a sliding shelf, you must first of all completely unload it. Then lift out the sliding tray by sliding it forwards whilst at the same
time lifting it from the front. Find the runner guides on the left and right and remove. Then reinstall them in the new position as shown below:
Wall
Wall
Guide
Then replace the sliding drawer as shown
opposite:
N.B.: The half sliding shelf at the bottom of the cabinet is fixed in place.
7 - C

I- Connecting

Check that your plug is connected to a power supply (presence of the correct amp fuses, functioning 30
mA differential circuit breaker (not applicable to some countries).
WAIT 48 HOURS BEFORE COMMISSIONING YOUR WINE CABINET.

II- Switching on the appliance

Plug in your cabinet. When you switch on the cabinet, the panel automatically lights up.
After a few minutes, if the set temperature is lower than the ambient temperature, the cold circuit indicator light comes on.
After a few seconds, the humidity level and temperature appear.
When the cabinet is used for the first time, the "charcoal filter" alarm
Your wine cabinet has a counter which displays the number of
To put your cabinet on standby, press and hold down the
10
- s
ayout
Guide
Setting up the rear part
of the guide
ommissioning your Wine CaBinet
torage
Setting up the front part
of the guide
Guide
Sliding shelf
Guide
will display. Reset the filter counter to 365 (see chapter 8-IV).
days the charcoal filter has been used (from 365 to 0 days).
key.
Wall
Shelf
support
Guide
Wall
Wall