Protecting The Enviroment And Energy-Saving; Installation - Eurocave Wine Bar 8.0 Mode D'emploi

4 - PROTECTING THE ENVIROMENT
Disposing of packaging
The packaging used by Eurocave Professional is produced in recyclable materials.
After unpacking your cabinet, take the packaging to a refuse collection point. For the most part, it
will be recycled.
Recycling: a caring gesture
Electronic and electrical equipment has potentially harmful effects on the environment and human
health, owing to the presence of dangerous substances.
Therefore, you must not trash electrical and electronic equipment with non-sorted municipal waste.
When purchasing a new Eurocave Professional product (wine cabinet, cellar conditioner, Vin au Verre,
Wine Bar 8.0), you can entrust the recycling of your old appliance to your Eurocave Professional
dealer.
Speak to your Eurocave Professional dealer, he will advise you on the disposal and collection arrangements set up within
the Eurocave Professional network.
In compliance with legislation on protecting and caring for the environment, your appliance does not contain C.F.C.s.
Energy-saving
• Install your cabinet in a suitable location and observe the recommended temperature ranges.
• Keep the doors open only for very short periods.
• Ensure that the door seals are intact and check that they are not damaged. If they are, contact your Eurocave
Professional dealer.
Disable unusable appliances by unplugging them and removing the power lead.
• Check, when your cabinet is delivered, that it does not have any external faults (impact, warping...).
• Open the doors and check the integrity of your appliance (walls, oxygen extraction heads, electronic controls...).
If there is a problem, contact your Eurocave Professional dealer.

Installation

Transport your appliance to the chosen location.
Place the glass cover on top of the appliance and put in place the drip pans
for condensate.
It must:
• be open on the outside to allow air to circulate
(not a closed cupboard...)
• not be close to any heat source,
• not be too damp,
• have a stable, flat support,
• have a power supply (standard socket, 16 A, earthed with circuit breaker, 30 mA* (*not applicable to some countries).
Precautions
• Do not place your cabinet in an area likely to be flooded.
• Do not position your cabinet near to a source of heat or expose it to the effects of direct sunlight.
• Prevent water from splashing on the entire rear section of the appliance.
• Position your appliance so that there is a minimum space of 5-10 cm between the wall and the rear wall of your cabinet.
• Arrange the power lead so that it is accessible and does not come into contact with any component of the appliance.
• Tilt the appliance backwards to adjust the back feet (adjusted by screwing or unscrewing), so that the cabinet is inclined rearwards
by 2 - 3° (this allows the condensation to drain away).
• Do not obstruct the ventilation holes at the back of the appliance.
AND ENERGY-SAVING
5 - INSTALLATION
MAX 40 kG
X2
2
i
-19-