Creating A Configuration List - Aventics AES Série Manuel D'utilisation

78 AVENTICS | Bus Coupler AES/Valve Driver AV, PROFIBUS DP | R412018135–BAL–001–AG
PLC Configuration of the Valve System
5.4.2

Creating a configuration list

The configuration described in this section refers to the example from Fig. 3.
1. In your PLC configuration software, open the window that displays the configuration
and the window that contains the modules.
2. Use your mouse to drag the individual modules into the correct sequence from the "Module
Selection" window into the configuration window.
The module selection window contains a list of all available devices. The designation used in the PLC
configuration key is stated in parentheses after the module designations.
...
...
3. Assign the desired output address to the valve drivers and output modules and the desired input
address to the input modules.