Base Plates; Transition Plate; Pneumatic Supply Plate - Aventics AES Série Manuel D'utilisation

96 AVENTICS | Bus Coupler AES/Valve Driver AV, PROFIBUS DP | R412018135–BAL–001–AG
Conversion of the Valve System
Fig. 7: Base plates, 2x and 3x
12.2.1

Base plates

The valves from the AV series are always mounted on base plates that are assembled into blocks so
that the supply pressure is applied to all valves.
The base plates are always 2x or 3x base plates for two or three single or double solenoid valves.
20
20
 Valve position 1
 Valve position 2
 Valve position 3
12.2.2

Transition plate

The transition plate (29) has the sole function of mechanically connecting the bus coupler to the
valve zone. It is always located between the bus coupler and the first pneumatic supply plate.
Fig. 8: Transition plate
12.2.3

Pneumatic supply plate

Pneumatic supply plates (30) can be used to divide the valve system into sections with different
pressure zones (see section 12.5 "Conversion of the valve zone" on page 104).
Fig. 9: Pneumatic supply plate
21
20 Base plate, 2x
21 Base plate, 3x
29
29
30 30
21
P