Electrical system
Basic electric items are:
headlamp with two halogen bulbs (over and under):
low beam type: HB3 (12V-60W).
high beam type: HB3 (12V-60W).
parking light:
bulb type: W5W ( 12V-5W).
E
Electrical controls on handlebars:
rear turn signal indicators:
bulb type: R10W (12V-10W).
turn signal indicators:
bulb type: RW16W (12V-16W).
Horn.
Stop light switches.
Battery, 12V-10 Ah.
Generator 12V-480W.
Electronic voltage regulator, protected by 40A fuse
located at the side of the battery.
Starter motor, 12V-0.7 kW.
Taillight and stop light:
bulb type: P21/5W (12V-5/21W).
Number plate light:
bulb type: W5W (12-5W).
Notes
See "Replacing bulbs" on page 68 for relevant
instructions.
88
https://www.motorcycle-manual.com/
Fuses
The main fuse box (1, fig. 82) is located between the
headlight support and headlamp fairing. To expose the
fuses, take off the protective cover. The cover indicates
mounting positions and ampere ratings.
Two fuses (2, fig. 83) located at the side of the battery
protect the relay of the injection system and engine
control unit.
The fuse (3) protects the electronic regulator. Remove the
protective cap to access the fuses.
A blown fuse is identified by a broken inner filament
(4, fig. 84).
Important
To avoid possible short circuits, switch the ignition
key to OFF before replacing the fuse.
Warning
Never use a fuse with a rating other than the one
specified. Failure to observe this rule may damage the
electric system or even cause fire.