Lcd - Main Functions - Ducati SUPERBIKE 749R 2005 Manuel D'utilisation

8) EOBD light (amber).
This light is lit steadily if the engine control unit has found
errors and has therefore blocked the engine.
The light is also used for visual information signals during
the procedure for releasing the immobilizer using the
throttle twistgrip.
When no errors are present, the light should come on
E
when the ignition switch is set to ON and should go out
after a few seconds (normally after 1.8 – 2 sec.).
9) Gear change threshold light (red)
Indicates that control unit has activated the injection
limiter. The lower part of the light comes on 200 rpm
below the injection limiter switch-on rpm; the top part of
the light comes on 100 rpm below the injection limiter
switch-on rpm.
10)Control buttons
These buttons are used to view and set instrument panel
parameters.
12
https://www.motorcycle-manual.com/
LCD – Main functions (fig. 5)
Warning
Stop the motorcycle before working on the instrument
panel. Never attempt to make changes to the instrument
panel while riding.
1) Speedometer.
Indicates road speed
2) Odometer.
Shows total distance travelled.
3) Trip meter.
Indicates distance covered since last reset.
4) Clock.
5) Lap time.
6) Top lap speed recording.
7) Battery voltage indicator.
8) Air temperature indicator.
9) Fuel consumption indicator.
10)Coolant temperature indicator.
Indicates engine coolant temperature.
Important
Stop riding if the temperature reaches maximum
value, otherwise engine damage could result.