❐ Do not subject the device to extreme temperatures, severe temperature fl uctuations,
direct sunlight or moisture.
Handling the device properly
❐ Check the device for damages prior to each use. The device may not be used if
it, the mains cord or plug exhibit visible damages. Do not use the device if it had a
malfunction or has fallen down.
❐ If the device, mains cord or mains plug are defective, do not attempt to repair the
device yourself. In the event of damage, consult a qualifi ed professional in your area
or the customer service department to avoid any risks.
❐ In the event of damages / malfunctions, immediately deactivate the device.
❐ Never use the device with just one plate. Two plates must always be installed. If only
one plate is installed, the thermostat could malfunction as a result. The device could
overheat and short circuit resulting in damage to the device.
❐ Only use heat-resistant utensils for placing foods on or removing them from the
device. Keep metallic objects or other objects with sharp edges away from the device.
They may damage the coating of the plates. We recommend you use kitchen utensils
made of wood or plastic.
❐ Only use the accessories included or recommended by the manufacturer.
❐ Do not insert foods packed in aluminium foil, cling wrap, plastic bags or similar in the
device.
❐ Do not place fl ammable materials (e. g. cardboard, plastic, paper or candles) on or
in the device.
❐ Do not leave the device unattended when in operation.
❐ Do not move the device while it is in use.
❐ Do not allow the device to fall and do not subject it to strong percussions.
❐ Do not subject the device to extreme temperatures, severe changes in temperature,
direct sunlight or moisture.
❐ Remove the power plug from the socket
– if you are not using the device,
– if a fault occurs during operation,
– before removing the plates and / or changing them,
– before you clean and / or store the device.
❐ If you wish to remove the mains plug from the socket, never pull on the mains cable,
but always on the plug!
❐ Never submerge the device in water or other liquids! Make sure that the device, the
mains cord or the mains plug can not fall in water or are at risk of getting wet. If the
device falls in water, immediately disconnect the power supply.
❐ Never spray cold water on the plates during or directly after using the device. This
could damage the coating!
❐ Always allow the device to cool off completely before you clean and / or store it.
❐ Store the device in a clean, dry area that is out of the sun and not accessible to
children and animals.
41