Sandwich Plate - gourmetmaxx SW 072B Vario Chef 6in1 Mode D'emploi

• Always let the device heat up before using it. During the pre-heating process,
you can arrange the foods you would like to prepare.
• If you suspect that food is "sticking" to the plates, add a drop of oil to the
plates before placing the food on them and distribute it with a pastry brush.

Sandwich plate

You can use these plates to prepare sandwiches with delicious toppings. Let your
imagination run wild when it comes to toppings: from ham and cheese or pizza sauce
and mozzarella up to and including fruit toppings – anything is possible. You can prepare
two sandwiches at the same time.
1. Insert the sandwich plates in the device as described in the chapter "Inserting and
changing the plates".
2. Connect the device to a properly installed, easily accessible socket. The red power
LED will illuminate as soon as the device has been connected to a socket.
3. The device must pre-heat now. Always keep the device closed during this time. The
pre-heating process takes about 3–5 minutes and has ended when the green power
LED illuminates.
4. Prepare your sandwiches during the pre-heating process.
• Place a topping of your choice on the bottom half. Place the topping in the
middle of the slice of toast. Make sure not to add too much of the topping to
the slice of toast as the device will press the slices of toast together and cut
them in half. Otherwise the topping will leak down the sides of the sandwich.
• To enhance the fl avour, coat the outside of the slices of toast with a small
amount of butter or margarine. Sandwich toasts can of course also be
prepared without butter – whatever you prefer.
• If you are preparing "sweet" sandwiches, e. g. with fruit toppings, you can
coat the outside of the toast slices with sugar for an extra crispy result.
5. When the green power LED illuminates and the pre-heating process has ended,
release the latch and open the device.
6. Insert the topped slice of toast in the bottom half of the device with the side coated
with butter or margarine facing down and place the second slice of toast so that it
covers (with the side coated with butter or margarine facing up) the fi rst slice of toast.
7. Close the device and lock it with the latch so that it stays closed during the baking
process. Please note that the green power LED may alternately turn off and back on
during the baking process. If the green power LED illuminates, this indicates that the
device is reheating to maintain a constant temperature.
8. After approx. 2–3 minutes open the device to check whether the sandwich has
already been toasted to perfection or whether it needs to be toasted longer.
9. When the sandwich is done, use wooden or plastic kitchen utensils to remove it to
prevent damage to the coating.
10. If you do not plan to toast any other sandwiches, pull the mains plug out of the socket
and let the device cool off completely before you remove and clean the plates and
store them together with the device.
45