Grill Plates; Waffl E Plates - gourmetmaxx SW 072B Vario Chef 6in1 Mode D'emploi

Grill plates

With these plates, you can use the device like an electric tabletop grill. The plates are
suitable for preparing all kinds of meat, fi sh and vegetables.
1. Insert the grill plates in the device as described in the chapter "Inserting and changing
the plates".
2. Connect the device to a properly installed, easily accessible socket. The red power
LED will illuminate as soon as the device has been connected to a socket.
3. The device must pre-heat now. Always keep the device closed during this time. The
pre-heating process takes about 3–5 minutes and has ended when the green power
LED illuminates.
4. When the green power LED illuminates and the pre-heating process has ended,
release the latch and open the device.
5. Now place your food (e. g. patties for hamburgers, chicken fi llets or vegetables) on
the bottom grill plate.
• You can prepare your meals with the grill open or closed. However, please
keep in mind that the cooking time is longer when the grill is open as more
heat is lost when preparing meals this way.
• When you close the grill, make sure that the latch has correctly locked into
place to keep the grill closed while grilling.
• Only use wooden or plastic kitchen utensils to fl ip or remove food to prevent
damage to the coating.
6. The green power LED may alternately turn off and back on while grilling. If the green
power LED illuminates, this indicates that the device is reheating to maintain a
constant temperature.
7. If you do not plan to prepare any other foods, pull the mains plug out of the socket and
let the device cool off completely before you remove and clean the plates and store
them together with the device.
Waffl e plates
You can prepare delicious waffl es with these plates.
1. Insert the waffl e plates in the device as described in the chapter "Inserting and
changing the plates".
2. Connect the device to a properly installed, easily accessible socket. The red power
LED will illuminate as soon as the device has been connected to a socket.
3. The device must pre-heat now. Always keep the device closed during this time. The
pre-heating process takes about 3–5 minutes and has ended when the green power
LED illuminates.
4. When the green power LED illuminates and the pre-heating process has ended,
release the latch and open the device.
5. Now add the waffl e batter to the bottom waffl e plate. Do not overdo it so that the
batter is not pressed out on the sides when you close the device.
6. Close the device and lock it with the latch so that it stays closed during the baking
process. Please note that the green power LED may alternately turn off and back on
46