Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Please note: The pictures in this chapter may vary slightly from the actual
product (shape, colour etc.)
1. Select a pair of plates you would like to insert in the device, open the latch and open
the device.

Use

ATTENTION!
❐ Hot surfaces! Only hold the device by the plastic handles during operation and
shortly after turning it off. We recommend you wear kitchen gloves when handling
the device.
❐ Scalding hazard! Steam may be emitted from the device. Be careful when opening
or closing the device.
❐ Make sure that you do not overfi ll the device! The device should generally be easy to
close. Do not forcefully attempt to close the device!
❐ Be careful when fi lling the device with liquid waffl e batter! If your overfi ll the device,
the batter may run over the sides of the device.
❐ Never use the device with just one plate. Two plates must always been in place. If
only one plate is installed, the thermostat could malfunction as a result. The device
could overheat and short circuit resulting in damage to the device.
2. To insert a plate in the device, place the long catches of
the plate under the corresponding holders in the device
(see fi gure). It is not important whether you insert the
bottom or upper plate fi rst.
3. Then push the plate on the "open" side into the device
by applying slight pressure until the short catches on the
plate audibly lock into place (see fi gure).
4. A latch (see fi gure) is located on the bottom and on the
top part of the device. If you would like to take the plates
out of the device or change them, you must push the
corresponding latch towards the handle; the plate will be
ejected out of the device and can be removed.
44

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Z 08995

Table des Matières