26
7.10 GASKET AND SHIELD REPLACEMENT
At the end of each burning season inspect the shield and gasket below the manifold for warping or deteriora-
tion. Replace if necessary. Both are held to the manifold with machine screws. The shield and the 1/8" (3.2mm)
EN
fi bre cloth gasket are available from your Wolf Steel Ltd. dealer. At this time also check that the door gasket is
not worn or loose. Replace with 3/8" (9.5mm) high density fi breglass rope if necessary.
The airwash gasket and shield above the door should also be inspected and replaced if deteriorated
NOTE: Do not operate appliance if gasket, manifold shield or fi bre baffl e is deteriorated or missing.
Follow these instructions:
A.
Remove the rear bricks, then remove the baffl e.
B.
Remove the 2 nuts and bolts securing the secondary
air manifold in place.
C.
Remove the secondary air manifold and gasket.
Replace.
W415-1466 / 04.21.15
SIDE VIEW
SECONDARY AIR MANIFOLD
SLOT
AIRWASH
SHEILD
AND
GASKET
NUT AND
BOLT(x2)