Cradle Burner Removal; Valve Train Replacement - Napoleon Ascent Multiface Serie Manuel D'installation Et D'opération

maintenance
EN

12.4.3 cradle burner removal

Remove the door(s) refer to the "door removal / installation" section for instructions.
A.
Carefully remove the glass or rocks from the appliance.
B.
To remove the media bowl support from the appliance, lift the media bowl and the media bowl support up
C.
and out of the appliance. The media bowl support and media bowl are secured together and resting loose
in the firebox.
Remove the 4 screws securing the burner in place, as shown below. Then slide the burner off the orifice
D.
and remove from the appliance.
To reinstall the burner reverse these steps.
E.
C
12.5

valve train replacement

Remove the safety screen and main door(s). See "main safety barrier removal / installation" and "main
A.
door removal / installation" sections for detailed removal instructions.
Remove the burners, see "burner removal" section.
B.
Remove the 12 screws holding the valve train in place, as shown below.
C.
note:
A new gasket may be required when reinstalling the valve train assembly. Contact your local
authorized dealer/distributor.
Carefully lift the valve train assembly out far enough to access the manual shut off valve and turn to the
D.
off position. Disconnect the flex connector from the valve. You may now lift the valve train out of the
appliance.
54
W415-1285 / H / 08.07.18
note:
When reinstalling the burner, ensure that the venturi rest on the orifice.
MEDIA MEDIA BOWL
BOWL SUPPORT
D