Blackmagic Design Teranex Mini Mode D'emploi page 15

1
PoE+
3 4
Connectors
1 USB-C Port
Connects to the Blackmagic Teranex Setup software via a Mac or Windows computer
for adjusting settings and updating your Teranex Mini's internal software. Plug your
monitor calibration probe into the USB-C port.
2 Front Panel
The LCD display shows important information, and you can use the control buttons and
rotary knob to navigate settings menus.
3 Power
Standard built in IEC C14 connector for 90 – 240 volt AC power supply.
4 Ethernet PoE+
Connects to a network switch or computer so you can change settings using the
Teranex setup utility. A white 'link' LED is to the right of the Ethernet port. The Ethernet
port also supports Power over Ethernet Plus.
5 SDI Loop Out
SDI video loop output BNC connectors.
6 SDI In
Use these BNC connectors to plug in your SDI source video. A white LED to the right of
each 'SDI IN' BNC connector indicates video input lock. 8K inputs can be quad square
division or quad 2SI 12G-SDI up to 8Kp60 or dual link 12G-SDI up to 8Kp30 on SDI In
A and B. HD and Ultra HD video up to 2160p60 can be input to SDI In A by single
link 12G-SDI.
7 HDMI Out
HDMI outputs support quad square division HDMI in 8K. HD and Ultra HD video up to
2160p60 is sent from HDMI A. If you have an HD or Ultra HD monitor or TV connected
to the HDMI A output and an Ultra HD or 8K input, the source video is automatically
frame rate converted and down scaled to HD or Ultra HD to match the capabilities of
your display. Frame rate conversion is a factor of the source frame rate, for example 60
to 30 frames per second or 59.94 to 29.97 frames per second.
8 L – Analog
Left channel analog audio output RCA connector.
9 R – Analog
Right channel analog audio output RCA connector.
2
5
SDI LOOP OUT
A B C D
SDI IN
6
HDMI A HDMI B
8
HDMI C HDMI D
9
STEREO OUT
HDMI OUT
7
Teranex Mini – SDI to HDMI 8K HDR 15