Blackmagic Design Teranex Mini Mode D'emploi page 42

8 Ethernet PoE+
Connects to a network switch or computer so you can change settings using
Blackmagic Teranex Setup. The Ethernet port also supports power over Ethernet plus.
9 SDI Out
SDI video output BNC connector.
10 SDI Out
SDI video output BNC connector.
11 L – Analog or AES/EBU
Balanced left channel analog audio, or digital AES/EBU audio input XLR connector.
12 R – Analog, AES/EBU or Timecode
Balanced right channel analog audio, or digital AES/EBU audio input XLR connector.
Can also be configured for timecode input.
Switches
Teranex Mini Analog to SDI 12G's switches provide the following settings:
Switch 8 – Analog Audio, AES/EBU Audio
Set switch 8 to OFF to select balanced analog audio, or to ON for digital AES/EBU audio input.
Switch 7 – 7.5 IRE – 0.0 IRE
The USA and countries using NTSC with 7.5 setup should set switch 7 to OFF. If you're working
in countries not using 7.5 setup, set switch 7 to ON. This setting only affects composite or NTSC
S-Video outputs.
Switch 6 – SMPTE Levels – Betacam Levels
This setting selects between SMPTE or Betacam video levels. Set switch 6 to OFF for SMPTE
levels, or to ON for Betacam levels. SMPTE levels are more common and even Betacam SP
decks can use SMPTE levels so only switch this to Betacam if you are sure that Betacam levels
are being used.
Switch 5 – Component, Composite or S-Video
Set switch 5 to OFF to select analog component video input, or to ON for composite video and
S-Video analog inputs.
Switch 4 – Composite – S-Video
Set switch 4 to OFF to select composite video input, or to ON for S-Video input.
Switch 3 – SD to HD
Set switch 3 to 'on' to up convert the SDI output resolution from SD to HD if the Composite,
S-Video or Component inputs are SD. Set to 'off' to match the input resolution.
Switch 2 – HD to UHD
Set switch 2 to 'on' to up convert SDI output resolution to Ultra HD if the Component video
input is HD. Set to 'off' to match the input resolution.
Switch 1 – Input Audio / Timecode
Set switch 1 to 'on' to input timecode via the R channel audio XLR connector. Set to 'off' to
input audio.
Teranex Mini – Analog to SDI 12G 42