Blackmagic Design Teranex Mini Mode D'emploi page 58

Quad Link Selection Table
Quad SDI Output
Quad HD Split
Quad Link
Dual Link
Single Link
Blackmagic Teranex Setup Settings
The Teranex setup utility can change all the same settings that are available using the switches,
plus additional settings. You can access these settings by moving between the 'video,'
'configure,' and 'about' tabs.
The 'about' and 'configure' tabs are detailed in the 'changing settings' section in this manual.
The 'video' tab for Teranex Mini 12G-SDI to Quad SDI contains the following settings.
Video Processing Menu
SDI Output
Use this menu to select between SDI output options. The available options are single link, dual
link, quad HD split and quad link. These dictate how an 12G-SDI Ultra HD signal is split between
your converter's four SDI outputs.
While a 12G-SDI input signal can be output as quad link or quad HD split, 6G inputs can be split
into four 1.5G outputs, or two pairs 3G outputs. Lower bitrate inputs, such as 3G-SDI or 1.5G-SDI,
can be duplicated across all four outputs by choosing 'single link.'
3G Output
This lets you change the 3G-SDI output standard to maintain compatibility with equipment that
can only receive level A or level B 3G-SDI video. Level B is the default setting. These settings
only apply when outputting 3G-SDI video.
Adjust your SDI output settings using the 'video'
settings page in Blackmagic Teranex Setup.
Switch 8 Switch 7
OFF ON
OFF OFF
ON OFF
ON ON
Teranex Mini – 12G–SDI to Quad SDI
Switch Diagram
58