Blackmagic Design Teranex Mini Mode D'emploi page 22

Your HDMI monitor now shows the luminous intensity of the test patch in nits. Use your
3.13
monitor's menu to set its backlight or contrast so the reading is as close as possible to
100 nits for SDR or 400 nits for HDR. Select 'next' and press 'set'.
When your Teranex Mini SDI to HDMI 8K HDR says 'calibration probe ready', select
3.14
'Calibrate' and press 'set' to start the automated color calibration sequence.
3.15 The 10-15 minute calibration begins. Teranex Mini SDI to HDMI 8K HDR generates and
measures a wide range of colors at varying luminance values, comparing the measured
results against the expected values. When the procedure concludes, it generates a
calibration 3D LUT and shows a confirmation message.
Press 'set' to return to the color 'calibration' menu. Press 'menu' to return to the
home screen.
The generated 3D LUT is assigned '3D LUT 1' and enabled. By default, the 3D LUT is
named 'calibration LUT'.
NOTE
This 3D LUT is stored in your converter's internal memory, and we
recommend you use Blackmagic Teranex Setup to save it to your computer.
For more information on how to manage 3D LUTS, see the 'Blackmagic
Teranex Setup Settings' section.
Teranex Mini – SDI to HDMI 8K HDR 22