Get Started; Treatment Steps - Silk-n Lipo H5001 Mode D'emploi

7.
You're on your way to a trim and toned body! Treating with Silk'n Lipo is
easy. Just follow these steps for each part of the body you wish to treat.

7.1 Treatment steps

1.
2.
3.
4.
5.
a
6.
Lipo UM 3385A FDA Canada ED228-05.indd 17

Get started!

Use on clean, healthy skin (refer to section "16. Labeling").
Check that the batteries are well charged before use. If the battery/
error light is orange and blinks slowly, this indicates that the battery
is low.
Before each treatment, wet the electrode pad/s with a wet cloth or
with wet fingers., and place them on each treatment unit (see section
"4.4 Wetting the electrode pads"). Next, connect one or more
treatment unit/s to the belt (see "4. 1 Connecting the different parts").
Disconnect one of the connectors on one side, and then place the
belt around the area you wish to treat. Then reconnect the side you
just disconnected.
Adjust the tightness of the belt so that the treatment unit/s are
in good contact with your skin, and that the belt is firm and well
secured to your body.
If the belt is not tight against your skin, the EMS energy may
disconnect. If that happens, press the + button to re-select the EMS
energy level required.
Switch on. With the controls in view, press the control button on
each treatment unit. The green and orange indicator lights will go
on, and then go off after a second or so and the treatment unit/s
will vibrate once. When the treatment unit/s are in good contact
with the skin, the green operating light will blink slowly, and the laser
energy will start to work.
17
EN
27/11/2017 13:36:14