Silk-n Lipo H5001 Mode D'emploi page 86

4.4 Wetting the electrode pads
The electrode pads are required for the EMS to work, and they must be wet
before you start your treatment.
EN
1.
2.
a
4.5 Device charging
Charge the treatment unit/s before first use. The initial charge should take
around 6 hours. Subsequent charges should take around 3 hours. We
recommend you re-charge the device before each treatment.
1.
2.
Model H5003 UM 3627A no laser electrode pads combined ED199-12 clean.indd 14
Wet each electrode pad with a wet cloth or with wet fingers.
Then place the wet electrode pad onto the underside of each
treatment unit. Make sure that it fits firmly around the center
rectangle. You might need to manipulate it slightly, so that the
electrode pad lies flat on top of the treatment unit.
Electrode pad
Only wet the electrode pad, not the whole treatment unit.
Connect the empty stand/charging cradle to the electricity supply.
The 2 charging indicator lights will be constant green.
Place the treatment unit/s in the cradle so that they sit in the
designated grooves.
When the treatment unit is charging, the orange battery/error
y
indicator light on the treatment unit will flash on and off.
y When fully charged the battery/error indicator light (left) will
go off, and the green operating light (middle) will be constant
green.
Underside of the
treatment unit
14
27/11/2017 13:35:23