Using Fixed Stop; Using Fixed Stop Together With Autostop; Setting The Stop Position - Struers Unitom-5 Mode D'emploi

Using Fixed Stop

Using Fixed Stop
together with Autostop

Setting the Stop Position

Unitom-5
Instruction Manual
Fixed stop can be used together with the Autostop On function. In
this situation, the cutting stops at the first occurring stop signal.
If you want to be sure that the cutting is not stopped before a
certain position, Autostop should be set to Autostop Off in the
configuration, using fixed stop only.
Clamp the workpiece so that you can move the cut-off wheel
along the workpiece.
Press POSITION DOWN
along the workpiece, to the desired stop position. Remember
to take the wear of the cut-off wheel into consideration.
Press F3: ACT. to record the actual stop position. The stop
position is now identical to the desired position.
Move the cut-off wheel back into top position, and clamp the
workpiece correctly.
V
to move the cut-off wheel down,
25