Reading The Display; Reading The Display During The Cutting Process; Sleep Mode - Struers Unitom-5 Mode D'emploi

Reading the Display

A
B
Reading the Display during the
Cutting Process

Sleep Mode

Unitom-5
Instruction Manual
The display can show various kinds of information, for example
parameters for an ongoing process. During the cutting process the
screen could look as the following example:
Heading.
A
Inverted text: cursor position.
B
Function key options.
C
Feed The feed rate of the cut-off wheel pre-set before starting the
cutting.
Load Load indicator of the cutting motor. The moving black
column shows the status of the cutting motor:
Inside the white area: The cutting motor can be loaded
continuously.
In the grey overload area: The cutting motor can only be intermit-
tently loaded. The built-in thermo fuse might shut off the cutting
motor.
Wheel Position. The actual position of the cut-off wheel counted
from the top position of the cut-off wheel.
Stop Position The pre-set stop position counted from the top
position of the cut-off wheel.
To increase the lifetime of the display, the backlight is automa-
tically switched off if Unitom-5 has not been used for 15 min.
Press any key to re-activate the backlight.
The sample screens in this Instruction Manual show a number of
possible texts. The actual display screen may differ from the
examples in the Instruction Manual.
C
Please Note
11