Programming The Automatic Cutting Table; Positioning The Automatic Cutting Table - Struers Unitom-5 Mode D'emploi

Programming the Automatic
Cutting Table
Positioning the Automatic
Cutting Table
Automatic Cutting Table for Unitom-5
Instruction Manual
The desired number of cuts, the sample width and the wheel
thickness are pre-set before starting the cutting.
D
mO
Press MENU UP/DOWN
mN you want to change.
D
e
Press ENTER
Two square brackets [ ] appear around the value.
D
mO
Press MENU UP/DOWN
mN
the numeric value.
D
e
Press ENTER
Pressing Esc, aborts the changes, preserving the
original value.
D
Press F2, to toggle between SET STOP and AUT.
F2
TABLE in the display. Set to AUT. TABLE.
D
Use F3 <</F4>> to move the automatic cutting table.
The position of the automatic cutting table can be read on
the display.
Place the automatic cutting table as close to the cut-off wheel
as possible, yet leaving sufficient room for the desired
number of samples to be cut.
mON
to select the parameter
e
, to edit the value.
mON
to increase or decrease
e
, to accept the new value.
5