Display Contrast; Language; Unit; Autostop - Struers Unitom-5 Mode D'emploi

Display contrast

Language

Unit

Autostop

Return position

Feed reduction

F1 Default value

22
Unitom-5
Instruction Manual
The contrast settings of the display can be adjusted to suit the
individual preferences.
The language can be set to either English, German or French.
The position of the cut-off wheel and the Automatic Cutting Table
(optional) can be displayed in either mm or inches.
In the setting: On, Unitom-5 automatically stops cutting, when
the workpiece has been cut through.
In the setting: Off, Unitom-5 will only stop when it reaches the
pre-set stop position or the STOP
After cutting or after pressing STOP
the cut-off wheel can be set to three different functions:
Top: Unitom-5 automatically retracts the cut-off wheel to the top
position.
Start: Unitom-5 automatically retracts the cut-off wheel to the
original position of the cut-off wheel, at the time you pressed
s
START .
Stay: The cut-off wheel stays down. Use the Stay function for
bakelite bonded diamond or CBN cut-off wheels, as retraction
might destroy the rim of the cut-off wheel.
In the setting: On, Unitom-5 will reduce the pre-set feed speed, if
it is too high in relation to the cutting situation.
In the setting: Off, Unitom-5 will maintain the pre-set feed speed
throughout the cutting process. However, this might result in a
motor stopping due to overload.
The factory setting of every single value can be restored by
pressing the function key F1 when the appropriate value is
highlighted.
o
key is pressed.
o
, the return movement of