Struers Unitom-5 Mode D'emploi page 3

Unitom-5
Instruction Manual
Unitom-5
Safety Precaution Sheet
To be read carefully
before use
1. The operator(s) should be fully instructed in the use of the machine and
its cut-off wheels according to the Instruction Manual and the
instructions for the cut-off wheels.
2. The machine must be placed on a safe and stable support table. All
safety functions and guards of the machine must be in working order.
3. Use only intact cut-off wheels. The cut-off wheels must be approved for
min. 50 m/s.
4. Observe the current safety regulations for handling, mixing, filling,
emptying and disposal of the additive for cooling fluid.
5. The workpiece must be securely fixed in the quick-clamping device or
the like. Large or sharp workpieces must be handled in a safe way.
6. Do not touch anything inside the cutting chamber while positioning the
cut-off wheel with the position button.
7. Struers recommends the use of exhaustion as the materials to be cut
may emit harmful gasses or dust.
If optional rubber curtains are needed in order to cut long, protruding
workpieces:
1. Check with your local authorities whether rubber curtains are approved
as protection in your country.
2. Do not put the hands through the rubber curtain during operation of the
machine.
3. Protruding workpieces should be shielded or marked.
The equipment is designed for use with consumables supplied by Struers. If subjected to misuse, improper
installation, alteration, neglect, accident or improper repair, Struers will accept no responsibility for
damage(s) to the user or the equipment.
Dismantling of any part of the equipment, during service or repair, should always be performed by a qualified
technician (electromechanical, electronic, mechanical, pneumatic, etc.).