Accessories - Struers Unitom-5 Mode D'emploi

Error
Samples not cut to set thickness +/-
0.2 mm.
Subject
Number of cuts:
Sample
Thickness:
adjustable in steps of:
Positioning range at right angles to the
Positioning
cut-off wheel-
adjustable in steps of:
Max. positioning speed
Specification
Replacement Stainless Steel Bands
For Automatic Cutting Table (UNIEL) and Cutting Table with 10 mm T-slots
(UNIFT). Set of three.
Quick-clamping Device for 10 mm T-slots, Left
For securing the workpiece. Complete with back stop. To be mounted on a
cutting table placed at the left hand side of the cut-off wheel.
Clamping Tools for 10 mm T-slots
For clamping complicated workpieces to the cutting table on Unitom-5 and
Unitom-2. Complete with clamps, supports and bolts.
8
Automatic Cutting Table for Unitom-5
Instruction Manual
1. Trouble-Shooting
Explanation
The sample moves during cutting.
The cut-off wheel bends.
Width of cut-off wheel not taken into
consideration.
The movement of the automatic
cutting table is blocked.
2. Technical Data
Metric/International
1-20
1-90 mm
0.1 mm
90 mm
0.5 mm
4 mm/s

3. Accessories

Action
Clamp the sample more solidly.
Use a lower feed speed.
Measure the width of the cut-off
wheel and compensate for the
actual width.
Remove possible obstructions
underneath the automatic cutting
table and clean around the table.
Check that the workpiece is not
clamped with the fixed cutting table
Specifications
US
0.04"-3.54"
0.004"
3.6"
0.02"
0.16 "/s
Code
UNIBA
UNILE
UNIOF