Instrument panel (fig. 4.1)
1) Speedometer (km/h or mph).
Gives road speed.
a) Odometer (km or miles).
Gives total distance covered.
b) Trip meter (km or miles).
Gives distance covered since last resetting.
c) Trip meter resetting knob.
Turn to reset trip meter to "0000".
2) Engine revolution meter (rpm)
Indicates engine rpm.
3) Green light N.
Comes on when gearbox is in neutral.
4) Yellow light
.
Comes on when there are about 6 liters fuel left in the
tank, corresponding to 1 bar of the digital display (9.1,
fig.4.2).
5) Green light
.
Comes on and flashes when a turn indicator is on.
6) Red light
.
Comes on when engine oil pressure is too low. It briefly
comes on when the ignition is switched to ON and
normally goes out a few seconds after engine starts.
It may shortly come on when the engine is hot, however,
it should go out as the engine revs up.
Important
If this light stays on, stop the engine or it may suffer
severe damage.
7) Blue light
.
Comes on when high beams are on.
8) Digital display.
Offers four functions (see page 12).
9) Red light.
Comes on and flashes when the motorcycle is stopped
(Immobilizer on).
Note
When the Immobizer has been activated, this light
keeps flashing for 48 hours and then goes out.The
Immobilizer is still working.
1
a
5
6
3
c
b
8
7
2
4
9
fig. 4.1
E
11