Storch HVLP SmartFinish 360 Mode D'emploi page 82

Fluid controller
Set knob to OFF. Increase fluid until desired flow is atta-
ined.
Air controller
Start with air control at the + position. To decrease atomi-
zation of fluid, adjust air control toward the - position.
Pattern size controller
Additional control of the pattern size is available by rota-
tion of the air cap retaining ring. Pattern size can be adju-
sted by rotating the retaining ring in either direction.
Spraying techniques
Before the workpiece is processed, first place a spray
sample on a test surface (paper).
Always adjust the operating pressure on the turbine to the
minimum possible to achieve the desired spray pattern.
An operating pressure that is too high will result in increa-
sed consumption of material as well as paint mist.
Aim gun straight at surface. Tilting gun to direct spray
angle causes an uneven finish.
Uneven finish
thick
thin
Original instruction
Even finish
even
82
Flex wrist to keep gun pointed straight. Fanning gun to
direct spray at angle causes uneven finish.
Uneven finish
thin thick thin
Triggering Gun
Pull trigger after starting stroke. Release trigger before
end of strike. Gun must be moving when trigger is pulled
and released.
NOTICE:
To prevent uneven spray pattern, start and end stroke off
of work piece surface.
Aiming Gun
Aim center of spray gun at bottom edge of previous stro-
ke, overlapping each stroke by half.
If gun does not spray, reference Troubleshooting.
Refilling cupinlet
1. Perform Pressure Relief Procedure.
2. Reference Fill Cup-System.
Even finish