Cleanup - Storch HVLP SmartFinish 360 Mode D'emploi

Cleanup

When cleaning gun with solvents, read all fire and explo-
sion hazard warnings.
Cleaning the gun after every job is important. Proper care
and maintenance results in optimal spray performance.
Cleaning Cup-System
NOTICE:
Strong solvents, such as lacquer thinner, can damage
parts of the Cup-System. Do NOT immerse parts of the
Cup-System in solvent.
1. Perform Pressure Relief Procedure.
2. Disconnect gun from Cup-System.
3. Loosen ring (1) from cup (5). Remove ring (1) and cover
(2) from cup. Verify the cupinlet (4) remains in cup upon
removal of cover and ring.
4. Return excess fluid to original container. Hold the
cupinlet (4) in place when pouring.
5. It is recommended to dispose of the used cupinlet
(4) and install a new one. If reusing, clean by wiping all
excess fluid from cupinlet (4).
NOTICE:
Dispose of cupinlets, cleaning materials, and unused fluid
according to local regulations. Refer to Safety Data Sheet
(SDS) of fluids used.
6. Wipe excess fluid from cover (2) and ring (1) of Cup-
System.
83 Original instruction