Storch HVLP SmartFinish 360 Mode D'emploi page 88

Problem
Cup system
Cup insert is not pressed
together
Material escaping bet-
ween cup and ring
Material escaping bet-
ween cup and gun
Material on cup base
Pulse-like spray pattern
Original instruction
Cause
Dirty sealing surfaces
Incorrect or no air cap attached
to gun
Air cap is loose
Gun air hose
Air coming out of the cup
Cup too full
Dirty sealing surfaces
Connections on the cup loose
Damaged O-ring connection on
the cup
Cup insert not inserted
Damaged cup insert
Cup system not fully ventilated.
Action
Remove ring, clean sealing surfaces, safely insert ring.
See Fill cup system.
Check air cap, replace if necessary.
Check that the retaining ring is completely attached.
Check that the retaining ring is attached so that the air
cap is not loose.
Check that the gun air hose is correctly connected to the
cup and gun.
Check that the gun air hose is not bent.
Damaged connection between cup and air connection.
Check that the connection is completely screwed in.
Replace cup system if necessary.
Check that the cup is not filled above the "MAX FILL"
line.
Remove ring, clean sealing surfaces, safely insert ring.
See Fill cup system.
Tighten connection. Use tool if necessary.
Replace o-ring. Grease O-ring to make installation easier.
Inserted cup insert.
Replace the cup insert.
See step 7 of initial operation.
88