How To Spray - Storch HVLP SmartFinish 360 Mode D'emploi

6. Connect air hose to inlet fitting of gun.
7. Verify trigger slide is in SPRAY position (A).
8. To ventilate the cup, turn on the turbine and aim the
gun at a test area (paper) and pull the trigger until an
even spray pattern is created.
NOTICE:
Tilt gun back and forth to help in evacuation of air.
9. You are now ready to spray.

How to Spray

The turbine motor generates sparks. These sparks can
ignite flammable fumes.
• Keep sprayer in a well ventilated area.
• Keep sprayer at least 6 m from spray area. Use additio-
nal hose if necessary.
Take a few moments prior to spraying and review these
tips to ensure your spraying project is a success.
Adjust Spray Pattern
Set air cap to position for spray pattern desired.
Adjusting material quantity and spray width
The material quantity and spray width can be adjusted
using the control buttons.
Pattern size
81
Air quantity
Material quantity
Original instruction