Technical Specifications; Warnings - Storch HVLP SmartFinish 360 Mode D'emploi

Technical Specifications

Sprayer
Maximum air pressure
Maximum operating pressure of fluid media
Permitted operating overpressure
Air inlet
for fluid inlet
Cup-system
Weight
SmartFinish 360 gun (without cup)
Cup system
Noise*
Sound pressure
Sound power
Wetted construction materials
Gun
Cup system
Notes
*Noise pressure measured at a distance of 1 metre from device. Noise level measured as per ISO-3744.
All information is without guarantee! Subject to technical modifications and errors!

Warnings

The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclamati-
on point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these
symbols appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific hazard
symbols and warnings not covered in this section may appear throughout the body of this manual
where applicable.
FIRE AND EXPLOSION HAZARD
Flammable fumes, such as solvent and paint fumes, in work area can ignite or explode. To help prevent fire
and explosion:
• Do not spray flammable or combustible materials near an open flame or sources of ignition such as ciga-
rettes, motors, electrical equipment, and plastic drop cloths (potential static sparking).
• Turbine motor generates sparks. Keep sprayer in a well ventilated area at least 6 m from the spray area
when spraying, flushing, cleaning, or servicing. Do not spray pump assembly.
• Connect to a grounded outlet and use grounded extensions cords. Do not use a 3-to-2 adapter.
• Do not use a paint or a solvent containing halogenated hydrocarbons.
• Do not spray flammable or combustible liquids in a confined area.
• Keep spray area well-ventilated. Keep a good supply of fresh air moving through the area.
• Do not smoke in the spray area or spray where sparks or flame is present.
• Do not operate light switches, engines, or similar spark producing products in the spray area.
• Keep area clean and free of paint or solvent containers, rags, and other flammable materials.
• Know the contents of the paints and solvents being sprayed. Read all Safety Data Sheets (SDSs) and conta-
iner labels provided with the paints and solvents. Follow the paint and solvents manufacturer's safety instruc-
tions.
• Keep a working fire extinguisher in the work area.
Quick-release system
5/8-16 UN-2A
Stainless steel, aluminium, UHMWPE, acetate, fluoroelastomer
Stainless steel, Grilamid, polyethylene, low-density polyethylene
75
0.7 bar
3.5 bar
3.5 bar
570 g
425 g
65.0 dBa
65.0 dBa
(LDPE)
Original instruction