How To Use - Meister MAS12VL Traduction Du Manuel D'utilisation Original

MW-5450680-Bediene-1711 23.11.17 13:50 Seite 72
The chuck of right/left
rotating machines is always
fixed with a left-threaded screw.
This must be loosened from the
front through the chuck (1) before
changing it. Left-threaded screws
can only be loosened by turning
to the right.
Switching on and off (Figure 5)
• Switching on:
Press the On/Off switch (10).
The screwing/drilling process
starts. During the screwing/
drilling process, keep the switch
pressed. The LED working
light (11) will light up.
• Switching off:
As soon as the screw or drill has
been screwed in or removed fully,
release the On/Off switch. The
screwing or drilling process is
completed, and the LED working
light will go out.
LED working light (Figure 5)
When the machine is switched on,
the LED working light (11) is lit to
provide better vision and to enable
safer work in darker areas. The LED
working light goes out when the
On/Off switch is released.
CAUTION! LED working light!
Do not look directly into the
beam of light as this may result in
damage to the eyes.
72
10 – How to use
Electronic revolution regulation
The electronic revolution regulation
can be achieved by adapting the
revolutions steplessly to the process
you are using.
• A light pressure on the On/Off
switch (10) = Low revolutions to
undo stubborn screws.
• Push down fully on the switch =
Highest revolutions to drill with.
CAUTION! When drilling or
using as a screwdriver, avoid
the motor coming to a standstill
under load!
Direction of rotation, right/left
(Figure 6)
The direction of rotation is
determined using the "Right/Left"
switch (5) above the power switch.
CAUTION! The direction of
rotation may only be changed
when the motor is at a standstill!
• Installing screws: Set the right/left
switch (5) to right rotation.
• Removing screws: Set the
right/left switch (5) to left rotation.
• Safety position: Centre switch
position; with the sliding switch in
this position, the machine cannot
be operated. Use, for example,
when taking a break or changing
bits or drills.