Front Cover Removal Instructions (Frames K - N Only); Fan Supply Voltage Selection (Frames K - N Only); Cabling Bracket For Control & Main Cable (Frames D - J Only) - Parker AC30 Série Guide De Démarrage Rapide

Front Cover Removal Instructions (Frames K - N only)

WARNING Isolate supply and ensure residual energy is discharged before removing the front cover.
The front panel of the inverter will need to be removed in order to access the fan voltage selection PCB. The installer
should check that the fan is set to operate on the correct supply voltage.
Removal of this panel also allows access to the AC line filter PCB, and in particular the Y-cap and VDR disconnects.

Fan Supply Voltage Selection (Frames K - N only)

With the front panel removed, ensure that the fan supply voltage selection link is correctly located according to the three
phase AC drive supply voltage, or the DC supply voltage to the drive.
When the drive is supplied with a DC supply voltage, an external 220VAC auxiliary supply is required to power the main
cooling duct fans. This needs to be wired into the terminal block TB1.
Cabling Bracket for Control & Main Cable (Frames D - J only)
When the bottom cover is removed, you can install the cabling brackets, if required.
The cabling brackets are standard with C2 filtered products as they are used to position the output ringcores. They can be
obtained from Parker using the following part numbers:
AC30V Frame E Illustrated
Drive Supply Voltage
380-420VAC
440-480VAC
510-650VDC
Link Position
PLG4
PLG5
PLG6
Cabling Bracket Kit Part Number
Frame
Size
Panel Mount
D
LA501935U001
E
LA501935U002
F
LA501935U003
G
LA501935U004
H
LA501935U005
J
LA501935U006
AC30D
English
Through Panel
LA503117U001
LA503117U002
LA503117U003
LA503117U004
LA503117U005
Not available
LA501935U007
Control cable
wiring bracket
Main cable
wiring bracket
1-7