Programming The First Somfy Io Local Control Point; Checking The Settings; Operation; Standard Operation - SOMFY Pergola io Notice

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
Pergola io
Setting the lower end limit
1) Put the awning in the lower end limit position.
Press and hold the Down button for > 2 seconds to
lower the awning in one continuous movement.
2) Stop the awning at the desired point.
3) If necessary, adjust the position of the awning using the
Up or Down buttons.
4) Press the "my" and Up buttons simultaneously: the
awning will be raised in one continuous movement, even
after the "my" and Up buttons have been released.
5) At mid-height, briefly press the "my" button to stop the
awning.
6) Press the "my" button again until the awning moves
briefly: the end limits have been programmed. Go to the
section "Programming the first Somfy io local control
point".

5.5. Programming the first Somfy io local control point

5.5.1. Using a programmed Somfy io local control point
- Briefly press the PROG button on this control point (G):
the awning will make a brief movement; the control point
has been programmed.
or
5.5.2. After a power cut
When the power is switched on, the awning makes a brief movement.
1) Press the Up and Down buttons simultaneously on the
new control point (H) until the awning moves briefly.
2) Briefly press the PROG button on this control point (H):
the awning will move briefly; the control point has been
programmed.

5.6. Checking the settings

- Check the settings of the upper and lower end limits using the Somfy io local control point.

6. OPERATION

6.1. Standard operation

6.1.1. Up and Down buttons
Briefly press the Up or Down button to raise or lower the
awning fully.
For tensioned Pergola awnings, obstacle detection is
active throughout lowering or raising.
6.1.2. STOP function
The awning is moving.
- Briefly press the "my" button: the awning will stop.
6.1.3. Favourite position (my)
Definition
Besides the upper and lower positions, an intermediate
position known as the "favourite position (my)" may be
programmed in the motor.
To program, modify or delete the favourite position (my),
see the section "Additional settings".
To use the favourite position (my):
- Briefly press the "my" button: the awning will start to move, and stop in the favourite position (my).
48
5069577C107-Pergola_io.indb 48
5069577C107-Pergola_io.indb 48
Copyright © 2010-2022 Somfy Activités SA, Société Anonyme. All rights reserved.
1
2
3
4
5
6
2 s
1
2
H
18/05/2022 18:46:29
18/05/2022 18:46:29

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pergola 50 ioPergola 60 io

Table des Matières