Correct Disposal Of This Product; Service And Repair - Steba SV 200 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
SV 200 Error Code
Error Code
Reason
E01
Low water level
The required
temperature
E02
could
not be reached
in a certain time

Correct Disposal of this product

This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the retailer
where the product was purchased. They can take this product for environmental safe
recycling.
Packaging disposal: Do not throw away the package materials. Please put it in the
recycling bin.
Gift box: Paper, should be put to the old paper collection point.
Plastic packaging material and foils should be collected in the
special collection containers.

Service and Repair:

If the appliance must be repaired, please get in touch with your trader or with the
manufacturer:
Service-Tel.: 09543 / 449-44, Fax: 09543 / 449-19
e-Mail: elektro@steba.com Internet: http://www.steba.com
Troubleshooting
∙ Check if the water level is lower than
∙ the „MIN" marking
∙ Check and ensure that the filter is not stuck
∙ Check if the water level switch and the
∙ relative circuit is ok (requires technical support)
∙ Check if the lid is closed
∙ Check and ensure that the filter is not stuck
∙ The machine was filled with cold water during
heating
∙ Check if the pump works normally
∙ Check if the heater works normally
∙ Check if the temperature probe works normally
(requires technical support for the point 4. 5. and
6.)
STEBA Elektrogeräte GmbH & Co KG
Pointstr. 2, 96129 Strullendorf / Germany
Distribution-Tel.: 09543 / 449-17 / -18,
19

Publicité

Table des Matières
loading

Table des Matières