Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20

Water quantity

Do not put too much water in the device - leave sufficient room for the food. If neces-
sary, top up water until Max. The unit can be switched on only when the water level
reaches the max marking. The food must always be covered with water. The tempe-
rature sensor needs a couple of minutes until he adjusted to the set temperature if
pre-heated water is filled in.
If there is no water in the pot, the device will not turn on and beeps E01.
Turn off the appliance, add water and start again.
The water level sensor switches off the appliance when the water level drops
rapidly
The last setting is shown on the display:
At first start the set production values appear, they are insignificant.
Temperature
Press the ON/OFF button. The display shows the current water temperature. Be care-
ful if you have set or degree Celsius or degree Fahrenheit.
By pressing the button "temperature +/-", you set the desired temperature (5 to 99
°C) in steps of 0,1 °C.
By pressing "+/-" longer, you can choose the temperature in the fast mode. Now
press time.
Time
By pressing the button "time +/-", you set the desired time (5 minutes to 99 hours)
in steps of 1 minute. By pressing "+/-" longer, you can choose the temperature in the
fast mode.
If you turn off the device with the "0/1" switch, plug it out, or if you have a
power outage, the unit remembers the last set values.
Start
Push the start button
tantly during cooking. This is an intended cooling function and not a defect.
You can see the symbol
heating you see
16
35,7
water temperature
57,4
set temperature
3:01
set time
The pump and the ventilation start running cons-
for the running pump in the display. While the appliance is
in the display. If you want to stop the device then press
.

Publicité

Table des Matières
loading

Table des Matières