Water Filter Drain Valve - Toto Washlet KM SW3036 Mode D'emploi

Maintenance

Water Filter Drain Valve

Close the shutoff valve.
1
• The water supply stops.
Extend the wand.
2
To operate from the back of remote control
(1)
(2)
To operate from the front of remote control
* Recommended if the remote control is locked to prevent theft.
(1)
(2)
(3)
Unplug the power plug.
3
Remove the cover and water fi lter drain valve.
4
• Loosen the water fi lter drain valve with a fl at-head screwdriver and then pull it.
Clean with a tool such as a toothbrush.
5
• Also, remove any dust from inside the hole of the water fi lter drain valve.
30
M08049-1_EN.indd 30 M08049-1_EN.indd 30
<If you think the water pressure has weakened>
CAUTION
Do not remove the water fi lter drain valve
while the shutoff valve is open.
(Otherwise, water may leak out.)
(Release the pressure from the water supply pipe.)
Press "Wand cleaning" button.
Press "Stopping" button on the front side of the remote control.
• The wand retracts.
Press "Stopping" button until all LEDs on the remote control start fl ashing.
(about 10 seconds)
Press "Front cleansing" button about 3 seconds or longer.
Press "Stopping" button on the front side of the remote control.
• The wand retracts.
Cover
Flat-head screwdriver
Water Filter
(Approximately once every 6 months)
Shutoff
valve
Water Filter Drain Valve
Drain Valve
Flat-head
screwdriver
10/5/2017 1:09:39 PM 10/5/2017 1:09:39 PM