Toto Washlet KM SW3036 Mode D'emploi page 6

Safety Precautions
Refrain from sitting on the seat for long periods.
 
It may cause low-temperature burns.
To prevent the following persons from getting a moderate temperature burn during use, other
person should turn off the toilet seat heater and set the dryer temperature to "Low".
 
Young children, the aged and other users unable to set the temperature appropriately
themselves.
  The ill, physically disabled and others who do not have freedom of movement.
 
Those using any medicines that cause drowsiness (sleeping or cold medicine), those who have
been drinking heavily, anyone severely fatigued and anyone else liable to fall asleep.
This is an electrical product. Do not install it anywhere water is likely to get on
the product or anywhere with humidity high enough that water is likely to form
on the surface of this product. When using the product in a bathroom, install a
fan or ventilation port and ensure good air fl ow through the bathroom.
 
Failure to do so may cause fi re or electrical shock.
Always connect the Washlet to the cold water supply.
 
Connecting to hot water supply may result in burns and equipment damage.
Make sure that a properly grounded (3 prong) outlet has been installed.
 
Failure to install a grounded outlet could cause electrical shock in the event of a malfunction or
short circuit.
Insert the power plug securely into the outlet.
 
Failure to do so may cause fi re, heat or short circuit.
To unplug, hold the power plug, not the power cord.
Do not unplug by pulling the power cord.
  Pulling on the power cord may cause damage and result in fi re or heat.
If the electric cord is damaged, avoid danger by having the manufacturer's
repair department or equivalent specialist replace it.
Always disconnect the power plug from the outlet before cleaning,
maintenance or inspection.
  Failure to do so may cause electrical shock or malfunction.
 
Except when using Wand Cleaning .
Periodically remove dust and dirt from the power plug and make sure it is
securely plugged into the wall outlet.
 
Failure to do so may cause fi re, heat or short-circuit.
Pull the power plug out from the outlet and wipe clean with a dry cloth.
Always unplug the plug from the outlet before removing the main unit.
  Failure to do so may cause a fi re or electrical shock.
6
M08049-1_EN.indd 6 M08049-1_EN.indd 6
WARNING
(Continued)
10/5/2017 1:09:29 PM 10/5/2017 1:09:29 PM