Energy Saver - Toto Washlet KM SW3036 Mode D'emploi

Troubleshooting
Trouble
The toilet seat
is cold
Trouble
The Energy
saver LED
does not light
up
The Timer

energy saver

feature is not
working
The Auto
energy saver+
or Auto energy
saver feature
is not working
44
M08049-1_EN.indd 44 M08049-1_EN.indd 44
Toilet Seat and Toilet Lid
▶
⚫Is the toilet seat temperature set to "OFF" or a low level?
⚫Is energy saver in operation?
• The energy saver feature is on when the "Energy saver" LED is on and the "Power"
LED is off on the main display.
▶
When you sit on the seat, the toilet seat heater is turned on temporarily and the seat
is warmed in about 15 minutes.
You can turn it "OFF" if the energy saver feature is "ON".
⚫Have you been seated for a long time?
• After about 20 minutes of sitting, the temperature starts going down, and after about
▶
1 hour, the toilet seat heater is turned "OFF".
use again.
⚫The seat switch will not turn on unless you sit on the seat properly.
▶
Sit back on the toilet seat.
▶
⚫Is a toilet lid or seat cover installed?
Energy Saver
⚫Did you unplug the power plug or was there a power failure?
• The "Energy saver" LED on the main display may go off when the power is turned
▶
on even if the energy saver feature is "ON".
(It will turn on within about 24 hours since the setting is retained.)
⚫Did you replace the remote control batteries?
▶
• "Timer energy saver" may be canceled when the batteries are replaced.
Set the "Timer energy saver" again at the time you want to start it.
⚫Because the function takes several days learning the usage conditions before starting
energy saver, the amount of energy saving may be low, depending on the frequency
▶
of use.
Check the energy saver setting.
⚫Did you replace the remote control batteries?
▶
• The settings may be canceled when the batteries are replaced.
Set them again.
Please check
Stand up from the seat and then
Remove any covers.
Please check
Ref.
Page
20
22
24
-
11
11
Ref.
Page
-
24
22
24
10/5/2017 1:09:45 PM 10/5/2017 1:09:45 PM