Basic Operations - Toto Washlet KM SW3036 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Basic Operations

Operate the controls on the remote control; a beep sounds when the main unit
receives the signal.
Stopping
"Stopping"
Stops the operation.
Cleansing
"Rear cleansing"
Cleanses your rear.
"Rear soft cleansing"
Cleanses your rear with
soft embracing water
fl ow.
 The setting changes between
and
each time the
pressed.
"Front cleansing"
Serves as a bidet for
ladies.
Drying
"Drying"
Dries your rear.
"Personal setting lock"
You can store your preferred "Wand position", "Water
pressure" and "Warm water temperature" settings.
● To store a settings
While cleansing is in progress, set your preferred "Wand position",
"Water pressure" and "Warm water temperature" and then press
and hold
or
● To use
Press
or
want to use.
 The "Wand position" and "Water pressure" lamps will light up for
about 10 seconds in their set positions, and the "Water temperature"
display switches.
*1 Remote control transmitter
16
M08049-1_EN.indd 16
M08049-1_EN.indd 16
is
for 2 seconds or longer.
, and then press the button for the cleansing you
● Functions that operate when a
button is pressed during "Rear
cleansing", "Rear soft cleansing"
or "Front cleansing" cleansing.
*1
Note
 Sitting back on the toilet seat
makes it easier to adjust the wand
position and to reduce splashing.
"Oscillating cleansing"
The wand moves back
and forth to wash your
rear thoroughly.
 The setting changes between "ON" and
"OFF" each time the button is pressed.
"Water pressure adjustment"
You can adjust the water
pressure to one of fi ve levels.
([-] Softer, [+] Stronger)
 After you press the "Water pressure
adjustment" button, the set position
will light for 10 seconds."
 Cleansing Buttons
Also, after pressing "Rear cleansing",
"Rear soft cleansing" or "Front cleansing",
the set position will light for 10 seconds.
"Wand position adjustment"
You can adjust the washing
position to 5 diff erent points
between the front and the rear,
using the [ ▲ ] and [ ▼ ] buttons.
 After you press the "Wand position
adjustment" button, the set position
will light for 10 seconds."
 Cleansing Buttons
Also, after pressing "Rear cleansing",
"Rear soft cleansing" or "Front cleansing",
the set position will light for 10 seconds.
10/5/2017 1:09:32 PM
10/5/2017 1:09:32 PM

Publicité

Table des Matières
loading

Table des Matières