Edit Channel Plan - Promax 27 Manuel

USER'S MANUAL. PROMAX-27
h) NOISE MEASUREMENT MODE
It measures the noise level. It is only applicable to digital channels. There are
three ways to measure noise: FREC (Absolute), where noise level is
measured at the frequency noise defined at field NOISE FREQUENCY (see
paragraph i); ∆F (Relative), where is added the value defined in the field
NOISE FREQUENCY to the tuner frequency and BW/2, where is added the
value defined in NOISE FREQUENCY to the frequency of half the bandwidth
of the tuned channel.
i) NOISE FREQUENCY
(Only for digital channels) Frequency at which is measured the level of noise
for digital channels.
j) STEP FREQUENCY
This option allows you to select the step frequency at the frequency tuning
modes and at the GENERATOR mode.
4.2.2.1

EDIT CHANNEL PLAN

To access the EDIT CHANNEL PLAN menu:
1.- Press key
2.- Press softkey [F5] (SETUP).
3.- Use the cursor keys
4.- Go to the parameter "EDIT CHANNEL PLAN" and press the selection key
[8].
It appears the screen with the configuration parameters (Figure 7).
The attached figure (Figure 7.-) shows an example of a channel plan. At the top of
the screen appears the name of the selected plan channel (CCIR in the attached
figure). Along the screen are listed the channels belonging to the channel plan. The
maximum number of channels that a plan channel could have is 140.
From left to right are the following columns:
NAME:
FREQUENCY:
OFFSET:
TYPE:
ACTIVE:
09/2010
[13].
[7] to scroll along the menu.
It identifies the channel name.
It identifies the frequency associated to the channel (MHz).
It shows the displacement of the tuning frequency in MHz.
It indicates whether the channel is defined as analog (A) or
digital (D).
It indicates whether the channel is active (Y) or not (N).
Page 19