Registered Mode - Ip Network Functions - Promax 27 Manuel

At the bottom of the screen (Figure 17.-) you will see next options:
BACK [F1]:
REF + [F3]:
REF - [F4]:
P1/P2/P3/P4 [F5]:
4.2.4 REGISTERED Mode — IP NETWORK Functions
In order to use the REGISTERED mode functions is necessary to register the
instrument in the network, configuring the information needed to identify it, such as IP,
Netmask and Gateway (refer to section 4.2.1). If you are not registered in the network
you will be able to access these functions but they will be disabled.
To access the REGISTERED mode, in order to analyse network services.
1.- Press key
2.- Press softkey MODEM [F1].
3.- Press softkey IP NETWORK [F1].
4.- The instrument starts the registration process in the CMTS of the NETWORK.
On the display it will appear the word "TUNING" during the process. You must
wait a few minutes until it is registered. If registration process is right, it will
display the word "DONE" on the screen. Failure in registration process will be
displayed as an "ERROR IN REGISTRATION".
It is displayed the REGISTERED mode screen. At the bottom menu it is shown
each one of functions that you may use (Figure 18.-).
Page 34
To return to the previous menu.
It moves up the reference margins of the power vertical
axis (from 80 to 120 dB).
It moves down the reference margins of the power
vertical axis (from 20 to 60 dB).
It allows changing the frequency values of the pilots.
Pressing this key you go through pilots values. P1 to
define the first reference frequency, P2 to define the
second reference frequency, etc ... To modify the
settings use the cursor or the alphanumeric keypad. If
using the arrow keys to change the frequency, the steps
are defined in the Frequency Steps setting (see 4.2.2).
If you use the alphanumeric keypad to define the
frequency, press SELECT to save the changes.
[13].
USER'S MANUAL. PROMAX-27
09/2010