Promax 27 Manuel page 121

USER'S MANUAL. PROMAX-27
This function can help you determine why a connection to a given server might be
poor, and can offer help you figure out where exactly the problem is.
It also shows you how systems are connected to each other, letting you see how
your ISP connects to the Internet as well as how the target system is connected.
To access the TRACEROUTE function:
1.- Press key
2.- Press softkey MODEM [F1].
3.- Press softkey IP NETWORK [F1].
4.- The instrument starts the registration process in the CMTS of the NETWORK.
On the display it will appear the word "TUNING" during the process. You must
wait a few minutes until it is registered. If registration process is right, it will
display the word "DONE" on the screen. Failure in registration process will be
displayed as an "ERROR IN REGISTRATION".
5.- Press softkey TRACE [F5].
Each line on the screen (Figure 22.-) shows each system or router in the path
between the instrument and the target system. Each line shows the system's IP address
and time in millisecond that is how long it took a packet to get from the instrument to
that system and back again.
If the device is not properly registered in the network, at the bottom of the screen
it will display the warning message "Register Error".
At the bottom of the screen appears following options:
BACK [F1]:
09/2010
[13].
DOCSIS/EuroDOCSIS ANALYSER
TRACE ADDRESS: 064.233.161.099
1: 10.1.1.5 10ms
2: 62.97.99.57 10ms
3: 213.27.253.85 13ms
4: 212.74.69.177 13ms
5: 212.74.65.58 36ms
6: 72.14.198.133 41ms
7: 209.85.249.178 75ms
8: 209.85.248.44 55ms
9: 66.249.94.251 75ms
10: 209.85.248.180 136ms
DONE
BACK SEND
Figure 22.- TRACEROUTE Screen.
Return to the previous screen REGISTER.
01:43:09
11: 209.85.248.216 140ms
12: 72.14.236.200 128ms
13: 64.233.161.099 150ms
Page 43