Iptv - Promax 27 Manuel

LATENCY:
JITTER:
If the device is not properly registered in the network, at the bottom of the screen
it will display the warning message "Register Error".
At the bottom menu it is shown each one of functions that you may use.
BACK [F1]:
SEND [F2]:
CONFIG [F4]:
CODEC / ADDRESS [F5]:
4.2.4.2

IPTV

Description of Service
IPTV (Internet Protocol Television) is a system where a digital TV service is
distributed on a network infrastructure using the IP protocol.
The protocol DOCSIS / EuroDOCSIS uses the concept of service flows for traffic
transmitted between cable modem and CMTS. A service flow is a one-way packets flow
that provide a specific service quality. Traffic is classified in a service flow, and each
service flow has its own set of parameters, named QoS.
QoS (Quality of Service) are technologies that ensure the transfer of certain
amount of data at a time, ensuring a good quality of service.
Page 38
It is the time delay, between initial input and output due to
transport or processing. It shows the minimum, average and
maximum measurement.
It is an unwanted variation of one or more characteristics of a
periodic signal. Jitter may be seen in characteristics such as
the interval between successive pulses, or the amplitude,
frequency, or phase of successive cycles. Are shown the
minimum, average and maximum measurements.
To return to the previous screen (REGISTERED).
To send the ping.
PING settings: PING data length; PING number.
UGS (Unsolicited Grant Services) settings: Enable UGS
(ON/OFF); Unsolicited Grant Size; Grants per Interval;
Nominal Grant Interval;Tolerated Grant Jitter. Use the
cursor to move among parameters and the selection
key [8] to enter and save them.
Pressing this key you can navigate among editable
parameters. To change them, use the Cursor keys or
the alphanumeric keypad as appropriate. You can
change the PING ADDRESS or the CODEC. When
selecting IP address, if you use the cursor keys you will
access to last IP entered by the user.
USER'S MANUAL. PROMAX-27
09/2010