Spectrum Function - Promax 27 Manuel

USER'S MANUAL. PROMAX-27
At the bottom of the screen are shown the following options:
SPECTRUM [F1]:
DIGITAL / ANALOG /
SLM [F3]:
TILT [F4]:
LEVEL / CHAN /
SPAN [F5]:
NOTE:
Access to the function SCAN / SPECTRUM switches depending on the type of
tuning you are doing.
In case you are tuning a signal using frequency, it will be displayed the
SPECTRUM function first.
In case you are tuning a signal using the predefined channels from the channel
plan, it will be displayed the SCAN function first.
4.2.5.4.2

SPECTRUM function

To access the SPECTRUM function:
1.- Press key
2.- Press softkey TV [F2].
3.- Press softkey [F1] to select the mode you want to work DIGITAL / ANALOG /
SLM.
4.- Press softkey SPECTRUM / SCAN [F3].
5.- Press softkey SPECTRUM [F1] (if coming from SCAN screen).
This function is the same one than the SPECTRUM function in MODEM mode.
For more details refer to section 4.2.3.4.
09/2010
It leads to the SPECTRUM screen (refer to section
4.2.5.4.2).
Comes back to the previous screen (this option
changes depending on the screen you come from).
It leads to TILT screen (refer to section 4.2.5.4.4).
Pressing this key you can navigate among editable
parameters. To change them, use the Cursor keys or
the alphanumeric keypad as appropriate. It can be
edited the LEVEL, to change the margin of the power
on the vertical axis of the graph, CHANNEL, to change
the channel we are analysing; SPAN, to change the
frequency range shown on the horizontal axis of the
graph. Possible values are 10, 30, 100, 300 MHz and
MAX SPAN.
[13].
Page 53