Promax 27 Manuel page 98

To move along the channels you should use the Cursor key
To edit a selected channel you should press the key
the channel values.
If you want to edit a value you should use the alphanumeric keypad or the cursor
key.
At the bottom of the screen it appears the following options:
BACK [F1] and [F5]:
ALL D. / ALL A [F3].:
EDIT [F4]:
Page 20
EDIT CHANNEL PLAN: CCIR
NAME FREQUENCY OFFSET
C02 50.25 MHz +0.00 MHz
C03 55.25 MHz +0.00 MHz
C04 62.25 MHz +0.00 MHz
S01 105.25 MHz +0.00 MHz
S02 112.25 MHz +0.00 MHz
S03 119.25 MHz +0.00 MHz
S04 126.25 MHz +0.00 MHz
S05 133.25 MHz +0.00 MHz
S06 140.25 MHz +0.00 MHz
S07 147.25 MHz +0.00 MHz
S08 154.25 MHz +0.00 MHz
S09 161.25 MHz +0.00 MHz
BACK ALL DIG.
Figure 7.- Channel Plan Editor.
To return to the previous general configuration screen
CONFIG.
If you select this option you could change the type of
signal defined in all channels to digital or analogue, as
appropriate.
When selecting this option, you will access to the
CHANNEL EDIT mode (Figure 8.-) to configure the
parameters of the analogical or digital channel.
USER'S MANUAL. PROMAX-27
01:43:09
TYPE ACTIVE
D Y
D Y
D Y
D Y
D Y
D Y
D Y
D Y
D Y
D Y
D Y
D Y
EDIT BACK
[7].
[8] for moving between
09/2010