Common Functions In Tv Mode; Scan Function - Promax 27 Manuel

TONE / AM / FM /
OFF [F2]:
SPECTRUM / SCAN [F3]:
LOGGER [F4]:
FREQ / VOLUME /
CHAN [F5]:
4.2.5.4

COMMON FUNCTIONS in TV mode

Next we are going to explain the functions that are common to the three TV
modes.
4.2.5.4.1

SCAN function

To access the SCAN function:
1.- Press key
2.- Press softkey TV [F2].
3.- Press softkey [F1] to select the mode you want to work DIGITAL / ANALOG /
SLM.
4.- Press softkey SPECTRUM / SCAN [F3].
5.- Press key SCAN [F4] (if coming from SPECTRUM screen).
This function is the same one than the SCAN function in MODEM mode. For
more details refer to section 4.2.3.3.
Page 52
Pressing this key you can navigate among these four
options. These options are for change the sound heard
by the speaker of the instrument. With TONE you will
heard a tone, which changes depending on the signal;
FM, to listen to Frequency Modulation radio signal; AM,
to listen to Amplitude Modulation radio; OFF, to mute
speaker.
It goes to SPECTRUM function (refer to section
4.2.5.4.2) / SCAN function (refer to section 4.2.5.4.1).
Through this function you can store measurements in
the memory of the instrument for later viewing, printing
or transfer to a PC (refer to section 4.2.5.4.3).
Pressing this key you can navigate among editable
parameters. To change them, use the Cursor keys or
the alphanumeric keypad as appropriate. FREQ for
changing the frequency value of the tuned channel,
VOLUME to increase or decrease the sound volume
heard by the speaker of the instrument, CHANNEL for
changing the channel of the channel plan.
[13].
USER'S MANUAL. PROMAX-27
09/2010