Promax 27 Manuel page 106

Measurements displayed on the screen:
PWR:
ΣPWR:
FR:
CH:
BW:
:
The dotted line at the graph indicates the threshold level, below which will not
show any power signal.
At the bottom of the screen are shown the following options:
SPECTRUM [F1]:
SEARCH [F2]:
MODEM [F3]:
TILT [F4]:
LEVEL / CHAN /
SPAN [F5]:
NOTE:
Access to the function SCAN / SPECTRUM switches depending on the type of
tuning you are doing.
In case you are tuning a signal using frequency, it will be displayed the
SPECTRUM function first.
In case you are tuning a signal using the predefined channels from the channel
plan, it will be displayed the SCAN function first.
Page 28
It indicates the signal power.
It indicates the summation of power signals along the
frequency band (from 5 to 1000 MHz).
Carrier intermediate frequency.
Shows the channel and active plan channel.
Bandwidth of the signal.
Indicates whether the selected channel is digital or analogue.
It leads to the SPECTRUM screen (refer to section
4.2.3.4).
It makes an exploration of all channels DOCSIS /
EuroDOCSIS presents at the frequency band of the
active channel plan (refer to section 4.2.3.2).
Returns to the main screen MODEM (refer to section
4.2.3).
Goes to TILT test (refer to section 4.2.3.6).
Pressing this key you can navigate among editable
parameters. To change them, use the Cursor keys or
the alphanumeric keypad as appropriate. It can be
edited the LEVEL, to change the margin of the power
on the vertical axis of the graph, CHANNEL, to change
the channel we are analysing; SPAN, to change the
frequency range shown on the horizontal axis of the
graph.
USER'S MANUAL. PROMAX-27
09/2010