Test Signal Generator Mode - Promax 27 Manuel

At the bottom of the screen you will see next options:
BACK [F1]:
REF + [F3]:
REF - [F4]:
P1/P2/P3/P4 [F5]:

4.2.6 TEST SIGNAL GENERATOR mode.

To access the TEST SIGNAL GENERATOR mode:
1.- Press key
2.- Press softkey GTOR [F3].
It is displayed the TEST SIGNAL GENERATOR screen (Figure 32.-).
This function creates a test signal to check the upstream traffic.
Page 58
To return to the previous menu.
It moves up the reference margins of the power vertical
axis (from 80 to 120 dB).
It moves down the reference margins of the power
vertical axis (from 20 to 60 dB).
It allows changing the frequency values of the pilots.
Pressing this key you go through pilots values. P1 to
define the first reference frequency, P2 to define the
second reference frequency, etc ... To modify the
settings use the cursor or the alphanumeric keypad. If
using the arrow keys to change the frequency, the steps
are defined in the Frequency Steps setting (see 4.2.2).
If you use the alphanumeric keypad to define the
frequency, press SELECT to save the changes.
[13].
Figure 32.- Setting parameters of the test signal.
USER'S MANUAL. PROMAX-27
09/2010